Tools and materials I propose:
In this video I make a wooden flask on the lathe.
I started by squaring my stock on the jointer/planer and table saw. My stock was 8cm thick.
Then I found all my centre points and cut the basic shape on the bandsaw.
I then started turning between centres with the bowl gouge. I then drilled the hole on the bottle’s neck.
To make the bottom concave I used a detail spindle gouge.
Once I finished the hollowing process I cut off the piece from the chuck.
To hollow the inside of my container I used a glue chuck with some epoxy.
Then I started turning the caps out of mahogany. I used some hard wood to add a decorative burning line.
Finally I made the cap out of mahogany again and finished the piece with mineral oil.
It was a really interesting piece that required turning in two axis. But that was it. See you soon with a new project video.
Disclosure: Some of the links below are affiliate links, meaning, that at no cost to you, I get a small commission if you click through and make a purchase.
0 komentar:
Posting Komentar