Tools and materials:
Air compressor, nail and staple gun kit
In this video I make a simple tool box out of plywood.
I begun by cutting my plywood to basic size on the table saw.
I then cut the sides on the bandsaw and sanded them on the belt sander.
I used a hole saw to add a dowel as a handle. Because the dowel was slightly larger I used a sanding bit to enlarge the holes.
I then glued and nailed the parts in place. I also added screws.
Next I made the cap. On the slides I added some wax to make it slide easier.
I added legs and also a divider in the inside.
Finally I turned a locking pin. This locks the cap in place.
I made this box basically for my turning tools but you can adapt it in any situation.
But that was it. See you soon with a new project video.
Disclosure: Some of the links below are affiliate links, meaning, that at no cost to you, I get a small commission if you click through and make a purchase.
0 komentar:
Posting Komentar